Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
All
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever the following DTCs are not present | None |
| Solenoid current cut status | Not cut |
| Engine switch | On (IG) |
| Starter | OFF |
Condition (A)
TYPICAL ENABLING CONDITIONS
| Condition (1) Battery voltage | 12 V or more |
| Condition (2) | - |
|
10 V or more and less than 12 V |
|
Less than 0 75 A |
| Condition (3) | - |
|
8 V or more |
|
0 25 A or more |
Condition (B)
TYPICAL ENABLING CONDITIONS
| Battery voltage | 11 V or more |
| Target current | 1 A or more |
Condition (C)
TYPICAL ENABLING CONDITIONS
| Battery voltage | 11 V or more |
| Target current | 0 1 A or more |
| Engine | Running |
| Difference between commanded voltage and last commanded voltage | Little to no difference |