Typical Malfunction Thresholds
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
When both conditions below are met: ON malfunction (A) and ON malfunction (B), (C) or (D)
2 detections are necessary per driving cycle:
1st detection: temporary flag ON
2nd detection, pending fault code ON
ON malfunction (A)
TYPICAL MALFUNCTION THRESHOLDS
| Oil pressure switch indication | ON |
ON malfunction (B)
When either condition below is met Condition (1) or (2)
Condition (1)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed / Output speed (NT / NO) | 0 93 or more and 1 07 or less (when output speed less than 800 rpm) |
Condition (2)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed - Output speed (NT - NO) x 6th gear ratio (Actual 6th gear) | -50 rpm or more and 50 rpm or less (when output speed 800 rpm or more) |
ON malfunction (C)
When either condition below is met. Condition (1) or (2)
Condition (1)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed / Output speed (NT / NO) | 0 759 or more and 0 889 or less (when output speed less than 800 rpm) |
Condition (2)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed - Output speed (NT - NO) x 7th gear ratio (Actual 7th gear) | -50 rpm or more and 50 rpm or less (when output speed 800 rpm or more) |
ON malfunction (D)
When either condition below is met: Condition (1) or (2)
Condition (1)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed / Output speed (NT / NO) | 0 62 or more and 0 75 or less (when output speed less than 1000 rpm) |
Condition (2)
TYPICAL MALFUNCTION THRESHOLDS
| Turbine speed - Output speed (NT - NO) x 8th gear ratio (Actual 8th gear) | -50 rpm or more and 50 rpm or less (when output speed 1000 rpm or more) |