Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever the following DTCs are not present | P0115, P0116, P0117 and P0118 (ECT sensor) P0125 (Insufficient ECT for closed loop) P0500 (VSS) P0748, P0778, P0798, P2810 and P2819 (Shift solenoid valve (range)) |
| Turbine speed sensor circuit | Not circuit malfunction |
| Input speed sensor circuit | Not circuit malfunction |
| Output speed sensor circuit | Not circuit malfunction |
| Shift solenoid valve SL1 circuit | Not circuit malfunction |
| Shift solenoid valve SL2 circuit | Not circuit malfunction |
| Shift solenoid valve SL3 circuit | Not circuit malfunction |
| Shift solenoid valve SL4 circuit | Not circuit malfunction |
| Shift solenoid valve SL5 circuit | Not circuit malfunction |
| Shift solenoid valve SR circuit | Not circuit malfunction |
| ECT (Engine coolant temperature) sensor circuit | Not circuit malfunction |
| ATF temperature sensor circuit | Not circuit malfunction |
| KCS sensor circuit | Not circuit malfunction |
| ETCS (Electric throttle control system) | Not system down |
| CAN communication circuit (ECM - TCM) | Not system down |
| NSW switch | "D" |
| Duration time from shifting "N" to "D" | 4 sec or more |
| ATF temperature | -10°C (14°F) or more |
| Engine | Starting |
OFF malfunction
TYPICAL ENABLING CONDITIONS
| Shift solenoid valve SL1 | Not OFF malfunction |
| Shift solenoid valve SL2 | Not OFF or ON malfunction |
| Shift solenoid valve SL3 | Not OFF or ON malfunction |
| Shift solenoid valve SL4 | Not OFF or ON malfunction |
| Shift solenoid valve SL5 | Not OFF or ON malfunction |
| Oil pressure switch | Not OFF malfunction |