Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
The stop light switch remains on during GO and STOP 5 times.
GO and STOP are defined as follows.
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever the following DTCs are not present | None |
| GO (Vehicle speed is 30 km/h (18 63 mph) or more) | Once |
| STOP (Vehicle speed is less than 3 km/h (1 86 mph)) | Once |
| Battery voltage | 8 V or more |
| Engine switch | On (IG) |
| Starter | OFF |