LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting (Exterior)) >> Stop Light Switch >> Inspection

Stop Light Switch: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT STOP LIGHT SWITCH ASSEMBLY 
    1. Measure the resistance according to the value (s) in the table below.
      Fig 1: Identifying Stop Light Switch Connector
      G05756607Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Switch Condition Specified Condition
      1 - 2 Pushed 10 kΩ or higher
      1 - 2 Not pushed Below 1 Ω
      3 - 4 Pushed Below 1 Ω
      3 - 4 Not pushed 10 kΩ or higher

      If the result is not as specified, replace the stop light switch assembly.

scientia non olet · About LEMON Manuals