LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting (Exterior)) >> Rear Combination Light Assembly >> Reassembly

Rear Combination Light Assembly: Reassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY 
    1. Connect the connector and install the rear combination light socket and wire sub-assembly.
    Fig 1: Locating Rear Combination Light Socket And Wire Sub-Assembly
    G05320476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL REAR TURN SIGNAL LIGHT BULB 
    1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.
    2. Turn the rear turn signal light bulb and rear combination light socket and wire sub-assembly in the direction indicated by the arrow in the illustration and install them as a unit
      Fig 2: Identifying Rear Turn Signal Light Bulb
      G05756551Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL REAR COMBINATION LIGHT BODY GASKET 
    1. Install a new rear combination light body gasket
      Fig 3: Identifying Rear Combination Light Body Gasket
      G05320474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals