LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Lighting (Exterior)) >> Rear Combination Light Assembly >> Disassembly

Rear Combination Light Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR COMBINATION LIGHT BODY GASKET 
    1. Remove the rear combination light body gasket.
      NOTE:
      • Be sure to remove all the traces of the old gasket from the body.
      • Do not reuse the removed gasket. Be sure to install a new rear combination light body gasket to prevent water ingress.
        Fig 1: Identifying Rear Combination Light Body Gasket
        G05320474Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE REAR TURN SIGNAL LIGHT BULB 
    1. Turn the rear turn signal light bulb and the rear combination light socket and wire sub-assembly in the direction indicated by the arrow in the illustration and disconnect them as a unit.
    2. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
      Fig 2: Identifying Rear Turn Signal Light Bulb
      G05320475Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY 
    1. Disconnect the connector and remove the rear combination light socket and wire sub-assembly.
      Fig 3: Locating Rear Combination Light Socket And Wire Sub-Assembly
      G05320476Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals