Headlight Assembly: Repair

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL UPPER HEADLIGHT PROTECTOR RETAINER
HINT
- If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.
- Ensure that the headlight assembly is not damaged.
1. Cut off the part shaded in the illustration and sand it smooth with sandpaper.
  NOTE: After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.
  
  Fig 1: Identifying Upper Headlight Protector Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the upper headlight protector retainer with the 2 screws.
  
  Fig 2: Identifying Upper Headlight Protector Retainer With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER HEADLIGHT PROTECTOR RETAINER
1. Cut off the part shaded in the illustration and sand it smooth with sandpaper.
  NOTE: After cutting off the part, place the headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.
  
  Fig 3: Identifying Lower Headlight Protector Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the lower headlight protector retainer with the 2 screws.
  
  Fig 4: Identifying Lower Headlight Protector Retainer With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002