Steering Knuckle: Installation

HINT.

• Use the same procedure for the RH side and LH side
• The procedure listed below is for the LH side.

1. INSTALL STEERING KNUCKLE 
   1. Temporarily install the steering knuckle to the upper suspension arm with the nut.
      Fig 1: Locating Upper Suspension Arm With Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the steering knuckle to the lower ball joint with the 2 bolts

      Torque: 120 N*m (1224 kgf*cm, 89 ft.*lbf) 

      Fig 2: Locating Lower Ball Joint With Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Fully tighten the nut and install a new clip

      Torque: 87 N*m (887 kgf*cm, 64 ft.*lbf) 

      NOTE: If the holes for the clip are not aligned, further tighten the nut up to 60°.
      Fig 3: Locating Steering Knuckle Clip

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY  (See INSTALLATION  )
3. INSTALL FRONT DISC  (See INSTALLATION )
4. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY  (See INSTALLATION )
5. CONNECT FRONT SPEED SENSOR WIRE  (See INSTALLATION )
6. INSTALL FRONT WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

7. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT 

   See ADJUSTMENT

8. CHECK FOR SPEED SENSOR SIGNAL 

   See TEST MODE PROCEDURE