Rear Brake Flexible Hose: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

REMOVE REAR WHEEL
DRAIN BRAKE FLUID
NOTE: Immediately wash off any brake fluid that comes into contact with any painted surfaces.
REMOVE REAR FLEXIBLE HOSE
1. Using a union nut wrench (10 mm), disconnect the rear flexible hose from the brake line
  NOTE:
  - Do not kink or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line.
  Fig 1: Disconnecting Rear Flexible Hose From Brake Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the clip from the rear flexible hose, and separate the rear flexible hose from the body bracket.
3. Remove the bolt and gasket, and remove the rear flexible hose from the rear disc brake cylinder assembly
Fig 2: Locating Union Bolt And Gasket
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002