Rear Brake Flexible Hose: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR FLEXIBLE HOSE
1. Install the rear flexible hose to the rear disc brake cylinder assembly with the bolt and a new gasket.
  Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
  
  NOTE: Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly.
  
  Fig 1: Locating Union Bolt And Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new clip to secure the rear flexible hose to the body bracket
  NOTE: Install the clip as far as it will go.
3. Using a union nut wrench (10 mm), connect the rear flexible hose to the brake line.
  Torque: without a union nut wrench
  
  15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  with a union nut wrench
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  Fig 2: Identifying Fulcrum Length
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
- Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
- This torque value is effective when the union nut wrench is parallel to the torque wrench.
- Do not kink or damage the brake line.
- Do not allow any foreign matter such as dirt and dust to enter the brake line.
FILL RESERVOIR WITH BRAKE FLUID (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See ON-VEHICLE INSPECTION )
INSPECT FOR BRAKE FLUID LEAK
INSPECT FLUID LEVEL IN RESERVOIR (See ON-VEHICLE INSPECTION )
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)