Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
All:
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | None |
P2111 (Throttle actuator stuck open):
TYPICAL ENABLING CONDITIONS
| All of the following conditions are met:- | |
|---|---|
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to close throttle | 80% or more |
P2112 (Throttle actuator stuck closed):
TYPICAL ENABLING CONDITIONS
| All of the following conditions are met: | - |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Duty cycle to open throttle | 80% or more |
| *System guard is ON when the following conditions are met: | - |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executing |
| Throttle position sensor | Fail determined |
| Throttle actuator current-cut operation | Not executing |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator | Fail determined |