LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Engine Control System (2GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation) >> Integration Relay >> Removal

Integration Relay: Removal

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  3. REMOVE INTEGRATION RELAY 
    1. Remove the No. 2 relay block cover.
    2. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 2 relay block.

      HINT:

      Tape the screwdriver tip before use.

    3. Disconnect the 3 connectors.
    Fig 1: Removing Integration Relay Claws
    G05285396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals