LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 176 (Engine Control System (2GR-FSE) - System And Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation) >> Crankshaft Position Sensor >> Inspection

Crankshaft Position Sensor: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CRANKSHAFT POSITION SENSOR 
    1. Measure the resistance between the terminals.

    Standard resistance 

    TERMINALS RESISTANCE REFERENCE

    Temperature Specified Condition
    Cold 1,630 to 2,740 Ω
    Hot 2,065 to 3,225 Ω
    Fig 1: Identifying Terminals Of Crankshaft Position Sensor Connector
    G04973877Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE: In the table above, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the sensor.

scientia non olet · About LEMON Manuals