LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Engine Control System - SFI System Diagnostics (1 Of 4)) >> DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS CHART

The monitor will run whenever these DTCs are not present P2610 (ECM internal engine off timer)
Both of the following conditions are met Conditions 1 and 2
1 All of the following conditions are met Conditions (a), (b), (c) and (d)
(a) After engine switch on (IG) and engine not running time Less than 20 seconds
(b) Soak Time 7 hours or more
(c) Battery voltage 10 5 V or more
(d) Time after engine start 15 seconds or more
2 Either of the following conditions is met Condition (a) and (b)
(a) Minimum intake air temperature after engine start -10°C (14°F) or more
(b) Engine coolant temperature before engine start -10°C (14°F) or more
scientia non olet · About LEMON Manuals