Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not present | None |
| All of the following conditions are met | - |
| Starter | OFF |
| Engine switch | on (IG) |
| Time after engine switch off to on (IG) | 0 5 seconds or more |
| One of the following conditions is met | Conditions A, B or C |
| A All of the following conditions are met | - |
| Battery voltage | 11 to 13 V |
| Target duty ratio | Less than 70% |
| Output signal duty ratio | 100% |
| B All of the following conditions are met | - |
| Battery voltage | 13 V or more |
| Target duty ratio | Less than 80% |
| Output duty ratio | 100% |
| C All of the following conditions are met | - |
| Current cut status | Not cut |
| Output signal duty ratio | 3% or less |