LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Engine Control System - System & Component Testing, R & I) >> Heated Oxygen Sensor >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT HEATED OXYGEN SENS OR 
    1. Disconnect the heated oxygen sensor connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      1 (HT) and 2 (+B) 20°C (68°F) 11 to 16 Ω

      If the result is not as specified, replace the sensor.

      Fig 1: Identifying Heated Oxygen Sensor Connector Terminal
      G05751997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals