Front Brake Flexible Hose: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT FLEXIBLE HOSE
1. Install the front flexible hose to the front disc brake cylinder assembly with the bolt and a new gasket.
  Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
  
  NOTE: Install the flexible hose lock securely in the lock hole in the front disc brake cylinder assembly.
2. Install a new clip to the front flexible hose.
  NOTE: Install the clip as far as it will go.
  
  Fig 1: Locating Union Bolt And Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a union nut wrench (10 mm), connect the front flexible hose to the brake line.
  Torque: without a union nut wrench
  
  15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  with a union nut wrench
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  NOTE:
  - Use a torque wrench with a fulcrum length of 250 mm (9.84 in.)
  - This torque value is effective when the union nut wrench is parallel to the torque wrench.
  - Do not kink or damage the brake line.
  - Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.
  Fig 2: Connecting Front Flexible Hose To Brake Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
FILL RESERVOIR WITH BRAKE FLUID (See ON-VEHICLE INSPECTION )
BLEED BRAKE LINE (See ON-VEHICLE INSPECTION )
INSPECT FOR BRAKE FLUID LEAK
INSPECT FLUID LEVEL IN RESERVOIR (See ON-VEHICLE INSPECTION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)