Purge Valve: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
HINT:

The No. 1 vacuum switching valve assembly is the purge valve.
1. Disconnect the No. 1 vacuum switching valve assembly connector.
2. Disconnect the fuel vapor feed hose and No. 2 fuel vapor feed hose from the No 1 vacuum switching valve assembly.
3. Remove the bolt and No. 1 vacuum switching valve assembly.
  
  Fig 1: Locating No. 1 Vacuum Switching Valve Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002