Purge Valve: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL NO. 1 VACUUM SWITCHING VALVE ASSEMBLY
HINT:

The No. 1 vacuum switching valve assembly is the purge valve.
1. Install the No. 1 vacuum switching valve assembly with the bolt.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 1: Locating No. 1 Vacuum Switching Valve Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the fuel vapor feed hose and No. 2 fuel vapor feed hose to the No 1 vacuum switching valve assembly.
3. Connect the No 1 vacuum switching valve assembly connector.
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )