Section 16 (Emission Control): Canister: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE NO. 1 FLOOR UNDER COVER
1. Remove the 3 nuts, 6 clips and No. 1 floor under cover.
Fig 1: Locating No. 1 Floor Under Cover, Nuts And Clips
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CHARCOAL CANISTER ASSEMBLY
1. Disconnect the wire harness from the 2 clamps
  
  Fig 2: Locating Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 2 quick connectors, hose and connector.
  
  Fig 3: Locating Quick Connectors, Hose And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 4 nuts and charcoal canister assembly.
Fig 4: Locating Charcoal Canister Assembly Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002