Scavenging Pump: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL SCAVENGING PUMP ASSEMBLY
1. Temporarily install the scavenging pump assembly and a new gasket with the 6 bolts.
2. Using several steps, uniformly install and tighten the 6 bolts in the sequence shown in the illustration.
  Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)
Fig 1: Locating Scavenging Pump Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 OIL PIPE
1. Install a new O-ring to the No 3 oil pipe.
2. Connect the No 3 oil pipe to the scavenging pump assembly and align the bolt holes.
  NOTE:
  - Be careful not to damage the O-ring.
  - Do not rotate the oil pipe when connecting it to the scavenging pump.
3. Install the No. 3 oil pipe with the 2 bolts
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig 2: Locating No. 3 Oil Pipe Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 OIL PIPE
1. Install a new O-ring and oil pipe seal to the No. 2 oil pipe.
2. Connect the No 2 oil pipe to the scavenging pump assembly and align the bolt holes
  NOTE:
  - Be careful not to damage the O-ring.
  - Do not rotate the oil pipe when connecting it to the scavenging pump.
3. Install the No 2 oil pipe with the 2 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig 3: Locating No. 2 Oil Pipe Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 OIL PIPE
1. Install a new O-ring and oil pipe seal to the No. 1 oil pipe.
2. Connect the No 1 oil pipe to the scavenging pump assembly and align the bolt holes.
  NOTE:
  - Be careful not to damage the O-ring.
  - Do not rotate the oil pipe when connecting it to the scavenging pump.
3. Install the No. 1 oil pipe with the 2 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig 4: Locating No. 1 Oil Pipe Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TIMING CHAIN COVER SUB-ASSEMBLY
HINT.

See INSTALLATION