LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Lubrication) >> Engine Oil Cooler >> Installation

Engine Oil Cooler: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE OIL COOLER 
    1. Clean the oil cooler contact surface on the cooler mounting.
    2. Apply a light coat of engine oil to a new O-ring.
    3. Install a new O-ring to the oil cooler.
    4. Install the oil cooler with the union bolt, bolt and new gasket.

      Torque: Union Bolt 

      59 N*m (602 kgf*cm, 43 ft.*lbf) 

      Bolt 

      10 N*m (102 kgf*cm, 7 ft.*lbf) 

      Fig 1: Identifying Bolt, Gasket, Union Bolt And Oil Cooler
      G05750488Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Connect the 2 water by-pass hoses.
    Fig 2: Locating Water By-Pass Hoses
    G05750487Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. ADD ENGINE OIL  (See OIL AND OIL FILTER )
  3. ADD ENGINE COOLANT  (See REPLACEMENT )
  4. CHECK ENGINE OIL LEVEL  (See LUBRICATION SYSTEM )
  5. INSPECT FOR OIL LEAK 
  6. INSTALL ENGINE UNDER COVER 
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
scientia non olet · About LEMON Manuals