LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Mechanical) >> Rear Crankshaft Oil Seal >> Removal

Rear Crankshaft Oil Seal: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY 

    See REMOVAL

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE ENGINE REAR OIL SEAL 
    1. Using a knife, cut through the oil seal lip
    2. Using a screwdriver with its tip taped, pry out the oil seal
      NOTE: After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.
      Fig 1: Removing Engine Rear Oil Seal
      G05749441Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals