LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Mechanical) >> Front Crankshaft Oil Seal >> Installation

Front Crankshaft Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL 
    1. Using SST, tap in a new oil seal until its surface is flush with the timing chain case edge

      SST 09223-22010,09506-35010 

      NOTE:
      • Keep the lip free from foreign matter.
      • Do not tap on the oil seal at an angle.
      • Do not install the oil seal excessively.
      Fig 1: Installing Timing Chain Case Oil Seal
      G04943590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CRANKSHAFT TIMING GEAR KEY 
    1. Install the crankshaft timing gear key
    Fig 2: Identifying Crankshaft Timing Gear Key
    G04943588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL CRANKSHAFT PULLEY 
    1. Align the pulley set key with the key groove of the pulley, and slide on the pulley
    2. Using SST, install the pulley bolt.

      SST 09213-38010, 09330-00021 

      Torque: 330 N*m (3365 kgf*cm, 243 ft.*lbf) 

  4. INSTALL V-RIBBED BELT  (See INSTALLATION )
  5. INSTALL RADIATOR RESERVE TANK ASSEMBLY  (See INSTALLATION )
  6. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
    Fig 3: Installing Crankshaft Pulley
    G05749439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. INSTALL ENGINE UNDER COVER 
scientia non olet · About LEMON Manuals