LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Brake System (Hydraulic)) >> Brake Master Cylinder >> Disassembly

Brake Master Cylinder: Disassembly

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
    1. Remove the brake master cylinder reservoir filler cap assembly from the brake master cylinder reservoir assembly.
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
    1. Remove the brake master cylinder reservoir strainer from the brake master cylinder reservoir assembly
  3. REMOVE BRAKE MASTER CYLINDER RING PIN 
    1. Mount the brake master cylinder sub-assembly in a vise.
      NOTE: Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
    2. Using a pin punch and a hammer, tap out and remove the brake master cylinder ring pin
  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY 
    1. Remove the brake master cylinder reservoir assembly from the brake master cylinder body.
    Fig 1: Removing/Installing Brake Master Cylinder Ring Pin
    G05752763Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
    1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
scientia non olet · About LEMON Manuals