Roof Drip Side Finish Molding: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE ROOF DRIP SIDE FINISH MOLDING
1. Put protective tape around the roof drip side finish molding
2. Using a molding remover, disengage the 6 clips and remove the roof drip side finish molding
  NOTE:
  - Do not remove the clips.
  - If the clips are damaged or dropped off, replace them with new clips.
    
    Fig 1: Identifying Roof Drip Side Finish Molding Clips
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 WINDSHIELD OUTSIDE MOLDING CLIP
HINT.

Perform the following procedure if replacing the No. 1 windshield outside molding clips
1. Remove the 5 No. 1 windshield outside molding clips
  
  Fig 2: Identifying No. 1 Windshield Outside Molding Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ROOF DRIP CENTER SIDE FINISH MOLDING
1. Put protective tape around the roof drip center side finish molding
2. Using a molding remover, disengage the 2 clips and remove the roof drip center side finish molding
  NOTE:
  - Do not remove the clips.
  - If the clips are damaged or dropped off, replace them with new clips.
    
    Fig 3: Identifying Roof Drip Center Side Finish Molding Clips
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 ROOF DRIP SIDE FINISH MOLDING CLIP
HINT.

Perform the following procedure if replacing the No. 1 roof drip side finish molding clips.
1. Remove the 2 No. 1 roof drip side finish molding clips
  
  Fig 4: Identifying No. 1 Roof Drip Side Finish Molding Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002