LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Exterior) >> Rear Door Belt Molding >> Removal

Rear Door Belt Molding: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR DOOR BELT MOLDING ASSEMBLY 
    1. Fully open the rear door glass
    2. Put protective tape on the door below the rear door belt molding assembly.
    3. Using a molding remover, disengage the 5 clips and remove the rear door belt molding assembly.
      Fig 1: Identifying Rear Door Belt Molding Assembly Clips
      G05756777Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals