Front Bumper: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE COOL AIR INTAKE DUCT SEAL
1. Using a clip remover, remove the 9 clips and cool air intake duct seal.
  
  Fig 1: Identifying Cool Air Intake Duct Seal Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR GRILLE PROTECTOR
1. Remove the 2 radiator grille protectors.
  
  Fig 2: Identifying Radiator Grille Protectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER ASSEMBLY
1. Using a screwdriver, turn the pins 90 degrees and remove the 2 pin hold clips.
  HINT:
  - Tape the screwdriver tip before use.
  - Use the same procedure for the RH side and LH side.
    
    Fig 3: Locating Front Bumper Assembly Pin Hold Clips
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. remove the screw.
  HINT:
  
  Use the same procedure for the RH side and LH side.
  
  Fig 4: Identifying Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Put protective tape around the front bumper assembly.
4. Remove the 8 screws.
  
  Fig 5: Identifying Front Bumper Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using a clip remover, remove the 2 clips and screw.
  
  Fig 6: Identifying Front Bumper Assembly Clips And Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Disengage the 10 claws and disconnect the front bumper assembly as shown in the illustration.
7. w/ headlight cleaner system:
  1. Disconnect the headlight cleaner hose.
    NOTE: Prepare a drain pan or a piece of cloth in case washer fluid leaks.
8. w/ intuitive parking assist system:
  1. Disconnect the ultrasonic sensor connector.
9. Disconnect the 2 fog light connectors and remove the front bumper assembly.
  
  Fig 7: Locating Fog Light Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002