Parking Brake Assembly: Disassembly

REMOVE REAR WHEEL
SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
1. Remove the 2 bolts and separate the rear disc brake caliper assembly.
  NOTE: Hang the caliper with wire or equivalent.
2. Remove the No. 1 caliper plate (2 pieces).
  
  Fig 1: Locating Rear Disc Brake Caliper Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DISC
1. Release the parking brake.
2. Put matchmarks on the rear disc and rear axle hub.
3. Remove the rear disc.
  HINT:
  
  If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns smoothly.
  
  Fig 2: Identifying Matchmarks On Rear Disc And Rear Axle Hub
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 PARKING BRAKE SHOE RETURN SPRING
1. Using SST, remove the No. 2 parking brake shoe return spring.
  SST 09703-30011
  
  Fig 3: Removing No. 2 Parking Brake Shoe Return Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 PARKING BRAKE SHOE RETURN SPRING
1. Using SST, remove the No. 1 parking brake shoe return spring.
  SST 09703-30011
  
  Fig 4: Removing No. 1 Parking Brake Shoe Return Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET
1. Slide the parking brake shoe, and remove the parking brake shoe adjusting screw set.
  
  Fig 5: Sliding Parking Brake Shoe
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY
1. Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
  SST 09718-00010
2. Remove the No. 2 parking brake shoe assembly.
  HINT:
  
  Use the service hole to retain the No. 1 hold down spring pin with your finger.
  
  Fig 6: Removing No. 2 Parking Brake Shoe Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY
1. Using SST, remove the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
  SST 09718-00010
2. Remove the No. 1 parking brake shoe assembly.
  HINT:
  
  Use the service hole to retain the No. 1 hold down spring pin with your finger.
  
  Fig 7: Removing No. 1 Parking Brake Shoe Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE SHOE LEVER
1. Remove the parking brake shoe lever.
Fig 8: Removing Parking Brake Shoe Lever
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PARKING BRAKE ANCHOR BLOCK
1. Remove the rear axle hub and bearing assembly (See REMOVAL ).
2. Remove the 2 nuts, cable support bracket and parking brake anchor block.
  
  Fig 9: Locating Parking Brake Anchor Block Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002