LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior >> Front Door Belt Molding >> Removal

Front Door Belt Molding: Removal

  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See DISASSEMBLY )
  2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY  (See DISASSEMBLY )
  3. REMOVE COURTESY LIGHT ASSEMBLY  (See DISASSEMBLY )
  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
  5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP  (See DISASSEMBLY )
  6. REMOVE FRONT DOOR FRAME COVER 
    1. Remove the nut and front door frame cover.
      Fig 1: Identifying Front Door Frame Cover Nut
      G05756772Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FRONT DOOR BELT MOLDING ASSEMBLY 
    1. Fully open the front door glass.
    2. Put protective tape on the door below the front door belt molding assembly.
    3. Using a molding remover, disengage the 7 clips and remove the front door belt molding assembly.
      4. Fig 2: Identifying Front Door Belt Molding Assembly Clips
      G05756773Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals