Front Bumper: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE COOL AIR INTAKE DUCT SEAL
1. Using a clip remover, remove the 11 clips and cool air intake duct seal.
  
  Fig 1: Identifying Cool Air Intake Duct Seal Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER ASSEMBLY
1. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
  HINT:
  - Tape the screwdriver tip before use.
  - Use the same procedures for the RH side and LH side.
    
    Fig 2: Turning Pin 90 Degrees
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Put protective tape around the front bumper assembly.
3. Using a clip remover, remove the 2 clips
4. Remove the 2 radiator grille protectors.
5. Remove the bolt and 10 screws.
  
  Fig 3: Identifying Front Bumper Assembly Bolt, Screws And Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.
  HINT:
  
  Use the same procedures for the RH side and LH side.
7. Disconnect the headlight washer hose, (w/ headlight cleaner system)
8. Disconnect the connector and remove the front bumper assembly.
Fig 4: Disconnecting Front Bumper Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002