LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting >> Rear Combination Light Assembly >> Inspection

Rear Combination Light Assembly: Inspection

  1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY 
    1. Measure the resistance according to the value (s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      1 - 2 OFF 10 kΩ or higher
      1 - 2 ON Below 1 Ω

      If the result is not as specified, replace the switch assembly.

      Fig 1: Identifying Back-Up Light Switch Assembly
      G05832249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals