Inspection Procedure

Please follow these pages (See HOW TO PROCEED WITH TROUBLESHOOTING ).

If the multiplex communication system is operating normally, proceed to the next step.

1. Connect the Techstream to the DLC3.
2. Ignition switch on (IG).
3. Turn the tester ON.
4. Enter following menus: Body Electrical / D-SEAT SW / Data List.
5. Check the values by referring to the table below.

   D-SEAT SW: 

   TESTER DISPLAY REFERENCE CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change SW	ODO/TRIP change switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-
   Trip Reset Sw	Trip Reset switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-

   OK: 

   Switch condition (ON/OFF) can be switched by actual operation. 

NG : REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY 

OK : REPLACE COMBINATION METER