Steering Pad: Removal

PRECAUTION
CAUTION: Be sure to read Precaution thoroughly before servicing (See PRECAUTION ).
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE LOWER NO. 3 STEERING WHEEL COVER
1. Using a screwdriver, disengage the claw and remove the No. 3 steering wheel cover lower.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Identifying Lower No. 3 Steering Wheel Cover Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE LOWER NO. 2 STEERING WHEEL COVER
1. Using a screwdriver, disengage the claw and remove the No. 2 steering wheel cover lower.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 2: Identifying Lower No. 2 Steering Wheel Cover Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE STEERING PAD
1. Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
  
  Fig 3: Locating Steering Pad Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
  NOTE: When removing the steering pad, do not pull the airbag wire harness.
  
  Fig 4: Identifying Steering Pad From Steering Wheel Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the horn connector from the steering pad.
4. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 5: Disconnecting Horn Connector From Steering Pad
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002