Front Passenger Airbag Assembly: Removal

DISCONNECT BATTERY NEGATIVE TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to the procedures up to "REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (see REMOVAL ).
REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT (See DISASSEMBLY )
REMOVE NO. 1 HEATER TO REGISTER DUCT (See DISASSEMBLY )
REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
1. Disconnect the 2 connectors and remove the instrument panel wire assembly from the front passenger airbag.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 1: Locating Front Passenger Airbag Assembly Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws.
  
  Fig 2: Identifying Front Passenger Airbag Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disengage the 5 hooks (A).
4. Disengage the 5 hooks (B) and remove the front passenger airbag from the instrument panel.
  
  Fig 3: Disengaging Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002