Front Passenger Airbag Assembly: Installation

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
1. Engage the 5 hooks (A).
2. Engage the 5 hooks (B) and install the front passenger airbag on the instrument panel.
  
  Fig 1: Locating Front Passenger Airbag Assembly Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 2 screws.
  
  Fig 2: Identifying Front Passenger Airbag Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the 2 connectors to the front passenger airbag.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 3: Locating Front Passenger Airbag Assembly Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 HEATER TO REGISTER DUCT (See REASSEMBLY )
INSTALL SIDE NO. 1 DEFROSTER NOZZLE DUCT (See REASSEMBLY )
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).