Instrument Panel Speaker: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. REMOVE SPEAKER HOLE COVER 
   1. Using a screwdriver, detach the 4 clips and remove the hole cover.

      HINT:

      Tape the screwdriver tip before use.

      Fig 1: Identifying Speaker Hole Cover Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. REMOVE FRONT STEREO COMPONENT SPEAKER ASSEMBLY 
   1. Remove the 2 bolts.
   2. Disconnect the speaker connector and remove the speaker.
      NOTE: Do not touch the cone part of the speaker.
      Fig 2: Locating Front Stereo Component Speaker Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 
   1. Using a screwdriver, detach the 2 clips and 2 claws.

      HINT:

      Tape the screwdriver tip before use.

   2. Remove the speaker panel.
   Fig 3: Identifying No. 2 Instrument Panel Speaker Panel Sub-Assembly Clips And Claws
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY 
   1. Remove the 2 bolts.
   2. Disconnect the speaker connector and remove the speaker.
      NOTE: Do not touch the cone part of the speaker.
      Fig 4: Locating Front No. 2 Speaker Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002