LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Starting (1UR-FSE)) >> Engine Switch >> Installation

Engine Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus GS 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE SWITCH 
    1. Attach the 2 claws to install the switch.
    2. Connect the switch connector.
  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  3. INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY  (See INSTALLATION )
    Fig 1: Identifying Engine Switch Connector
    G05287836Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL INSTRUMENT SIDE PANEL LH  (See INSTALLATION )
  6. INSTALL FRONT DOOR OPENING TRIM COVER LH  (See INSTALLATION )
  7. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  9. INSTALL CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  13. CHECK SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals