LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> GS 350 AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting (2GR-FSE) >> Engine Switch >> Installation

Engine Switch: Installation

  1. INSTALL ENGINE SWITCH 
    1. Attach the 2 claws to install the switch.
    2. Connect the switch connector.
  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See INSTALLATION )
  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL INSTRUMENT SIDE PANEL LH  (See INSTALLATION )
  6. INSTALL FRONT DOOR OPENING TRIM COVER LH  (See INSTALLATION )
    Fig 1: Identifying Engine Switch
    G05287836Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. INSTALL FRONT DOOR SCUFF PLATE LH  (See INSTALLATION )
  8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY  (See INSTALLATION )
  10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  12. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  13. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
scientia non olet · About LEMON Manuals