LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h FWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat >> REAR SEAT ASSEMBLY (for LH Side) >> Removal

REAR SEAT ASSEMBLY (for LH Side): Removal

  1. REMOVE REAR SEAT TRACK BRACKET COVER 
    1. Move the rear seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
    2. Using a screwdriver, disengage the 4 claws.

      HINT:

      Tape the screwdriver tip before use.

      Fig 1: Identifying Rear Seat Track Bracket Cover Claws
      G05274522Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull the 2 rear seat track bracket covers toward the rear of the vehicle and remove them.
  2. REMOVE REAR SEAT ASSEMBLY LH 
    1. Using a clip remover, remove the 3 clips.
    2. Remove the bolt and disconnect the floor anchor side of the fold seat stopper band assembly No.2.
    3. Move the rear seat assembly LH to the rearmost position by operating the rear seat track adjusting handle.
    4. Remove the 2 bolts on the front side.
    5. Move the rear seat assembly LH fully forward by operating the rear seat track adjusting handle.
    6. Remove the 3 bolts on the rear side.
    7. Move the rear seat assembly LH to the center position and adjust the seatback to the vertical position.
    8. Remove the rear seat assembly LH.
scientia non olet · About LEMON Manuals