LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Vehicle Control (P310) - RX400H - Inverter With Converter, Vehicle Control Ecu, Water Pump With Motor, Sub Radiator, Frame Wire, Accelerator Pedal Rod, Front/Rear Circuit Breaker Sensors, IGCT Relay >> Rear Circuit Breaker Sensor >> Inspection

Rear Circuit Breaker Sensor: Inspection

  1. INSPECT REAR CIRCUIT BREAKER SENSOR LH 
    1. Measure the resistance according to the value in the table below.

      Standard Resistance 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester Connection Specified Condition
      1( SCR-) - 2 (SCR+) 0.65 to 1.0 kΩ at 20°C (68°F)
      Fig 1: Identifying Rear Circuit Breaker Sensor LH Connector Terminals
      G05278992Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT REAR CIRCUIT BREAKER SENSOR RH 
    1. Measure the resistance according to the value in the table below.

      Standard Resistance 

      TESTER CONNECTION AND SPECIFIED CONDITION

      Tester Connection Specified Condition
      1 (SCR-) - 2( SCR+) 0.65 to 1.0 kΩ at 20°C (68°F)
      Fig 2: Identifying Rear Circuit Breaker Sensor RH Connector Terminals
      G05278993Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002