LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Vehicle Control (P310) - RX400H - Inverter With Converter, Vehicle Control Ecu, Water Pump With Motor, Sub Radiator, Frame Wire, Accelerator Pedal Rod, Front/Rear Circuit Breaker Sensors, IGCT Relay >> Front Circuit Breaker Sensor >> Removal

Front Circuit Breaker Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE ENGINE ROOM SIDE LH COVER NO.2  (See REMOVAL )
  3. REMOVE AIR CLEANER CAP W/INLET  (See REMOVAL )
  4. REMOVE CIRCUIT BREAKER SENSOR NO.1 
    1. Move the outer section to the wire harness side as illustrated, then disconnect the circuit breaker sensor No.1.
      Fig 1: Disconnecting Circuit Breaker Sensor No.1
      G05201734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and circuit breaker sensor No.1 from the w/ converter inverter assembly.
    Fig 2: Locating Circuit Breaker Sensor No.1 Bolts
    G05201855Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals