Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position.
3. Select the following menu items: DIAGNOSIS / OBD/ MOBD / HV ECU / DTC INFO / CURRENT CODES.
4. Read output DTCs. (See DTC CHECK / CLEAR )

   Result: 

   DTCs other than P3000-388 and P3000-389 are output. 

YES: GO TO  DTC CHART 

NO: Go to next step 

1. Put the vehicle into the READY-on state. Check if the engine starts.

   OK: The engine starts. 

YES: LEAVE VEHICLE IN P POSITION, AND CHARGE HV BATTERY IN IDLE STATUS UNTIL IDLING STOPS 

NO: Go to next step 

1. Turn the ignition switch off, move the shift lever to the P position, and lift up the vehicle.
2. Turn the crank pulley by hand to check if the crankshaft rotates.
   CAUTION: Do not put the vehicle into the READY-on state while performing this inspection. Be sure to turn the ignition switch off because the engine may start.

   OK: The crankshaft rotates. 

NG: GO TO step   4 

OK: REPLACE HV BATTERY 

1. Turn the ignition switch off, move the shift lever to the N position, and lift up the vehicle.
2. Turn the crank pulley by hand to check if the crankshaft rotates.
   CAUTION: Do not put the vehicle into the READY-on state while performing this inspection. Be sure to turn the ignition switch off because the engine may start.

   OK: The crankshaft rotates. 

OK: REPLACE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

NG: REPAIR OR REPLACE ENGINE