Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch to the ON position.
3. Select the following menu items: DIAGNOSIS / OBD/ MOBD / HV ECU / DTC INFO / CURRENT CODES.
4. Read output DTC. (See DTC CHECK / CLEAR )

   Result: 

   The DTCs shown in the table below are output 

   DTCS RESULT DESCRIPTION
   
   

   DTC No.	Relevant Diagnosis
   P0A1A, P0A1B	MG ECU malfunction
   P0A1D	HV control ECU malfunction

YES: GO TO  DTC CHART 

NO: REPLACE W/ CONVERTER INVERTER ASSEMBLY