Driver Side Knee Airbag Assembly: Installation

INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
1. Install the driver side knee airbag assembly with the 4 bolts.
  Torque: 7.6 N*m (78 kgf*cm, 68 in.*lbf)
2. Connect the connector to the driver side knee airbag assembly.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 1: Installing Driver Side Knee Airbag Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Some systems need initialization after reconnecting the cable to the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).