Inspection Procedure

HINT:

These codes are detected when a problem is determined in the brake actuator assembly.

The solenoid circuit is in the brake actuator assembly. Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.

1. Clear the DTCs (See DTC CHECK/CLEAR  ).
2. Turn the ignition switch to the ON position.
3. Check if the same DTCs are recorded.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is output	A
   DTC is not output	B

   NOTE: When replacing the brake actuator assembly, perform zero point calibration (See CALIBRATION  ).

B: END 

A: REPLACE BRAKE ACTUATOR ASSEMBLY  (See REMOVAL  )