Rear Brake Pad, Brake Caliper & Brake Rotor: Removal

HINT:

• Use the same procedures for the RH side and the LH side.
• The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL 
2. DRAIN BRAKE FLUID 
   NOTE: Wash the brake fluid off immediately if it adheres to any painted surfaces.
3. DISCONNECT REAR LH FLEXIBLE HOSE 
   1. Remove the union bolt and the gasket from the disc brake cylinder assembly rear, then disconnect the flexible hose.
4. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN 
   1. Remove the rear disc brake cylinder slide pin No. 2.
   2. Remove the rear disc brake cylinder slide pin.
      Fig 1: Identifying Rear Disc Brake Cylinder Slide Pin

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. REMOVE DISC BRAKE CYLINDER ASSEMBLY 
   1. Remove the disc brake cylinder assembly.
      Fig 2: Identifying Rear Disc Brake Cylinder Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002