Rear Brake Pad, Brake Caliper & Brake Rotor: Installation

INSTALL DISC BRAKE CYLINDER ASSEMBLY
1. Install the rear disc brake cylinder assembly.
  
  Fig 1: Identifying Rear Disc Brake Cylinder Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN
1. Apply the lithium soap base glycol grease to the sliding part and the seal surface of the slide pin.
2. Install the rear disc brake cylinder slide pin.
3. Apply the lithium soap base glycol grease to the sliding part and the seal surface of the slide pin No. 2.
4. Install the rear disc brake cylinder slide pin No. 2 to the bottom side of the cylinder mounting LH.
  
  Fig 2: Identifying Rear Disc Brake Cylinder Slide Pin & Cylinder Slide Pin No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Fully tighten the rear disc brake cylinder slide pin and the rear disc brake cylinder slide pin No. 2.
  Torque: 43 N*m (440 kgf*cm, 32 ft.*lbf)
  
  Fig 3: Identifying Rear Disc Brake Cylinder Slide Pin Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT REAR LH FLEXIBLE HOSE
1. Connect the flexible hose with the union bolt and a new gasket.
  Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf)
FILL RESERVOIR WITH BRAKE FLUID (See BLEEDING )
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK BRAKE FLUID LEAKAGE
INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)