Brake Master Cylinder: Installation

INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
1. Install the brake master w/ plate cylinder sub-assembly and the check valve bracket with the 2 nuts.
  Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf)
  
  Fig 1: Identifying Brake Master With Plate Cylinder Sub-Assembly & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST(s), connect the 2 brake tubes to the brake master w/ plate cylinder assembly.
  SST 09023-00101
  
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  Fig 2: Connecting Brake Tubes To Brake Master With Plate Cylinder Assembly Using SST(s)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Slide the clip and connect the reservoir tube.
  
  Fig 3: Identifying Reservoir Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER HOSE NO.1
INSTALL AIR CLEANER ASSEMBLY
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
FILL RESERVOIR WITH BRAKE FLUID
BLEED MASTER CYLINDER (See BLEEDING )
BLEED BRAKE LINE (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See BLEEDING )
CHECK BRAKE FLUID LEAKAGE